Most widely used are insulated connectors because they are usually designed for copper cables, can withstand higher voltages, and are tin plated for resistance to corrosion. Vinyl Insulated Butt Splices Vinyl butt splices are insulated and typically used for small wires, such as wire sizes from 10 - 22 AWG the standardized wire gauge system used in North America is the American Wire Gauge that dictates the diameters of round, solid, nonferrous, electrically conducting wire.
The insulation and vinyl sheath replaces the need for taping, and is most commonly used for small wire applications. The seamless barrel type of a vinyl butt connector is adequate for most wire connections and is the most economical option.
Nylon Insulated Butt Splices Nylon is a more rugged option over vinyl because it provides higher temperature resistance and is resistant to solvents.
It can have either a flared or straight insulator end opening and provides a maximum strength connection. Heat Shrink Insulated Butt Slices The heat shrinkable insulation has an adhesive liner which helps to seal the splice when exposed to a temperature that will heat shrink the insulation.
These are used most in instances where wire connections are subject to outdoor or environmental applications such as moisture and temperature differences. Connecting The Wires To The Butt Splice Connector Now you can see that it is necessary to understand what type of electrical connection you are going to need with the wires that are used. Below are some tips to determine how to achieve a safe and successful electrical connection using Butt Splice Connectors:.
Locate the end sections of the wire and strip the vinyl sheath until a specified length of wire is exposed. Determine the wire size gauge and correspond that to the correct color of butt splice connector. Make sure the electricity is shut off before handling any electrical wiring at the source. Also check that no electrical charge is present.
Slide the butt connector over the stripped wire ends covering the exposed wires. The metal sleeve inside the connector should completely cover the wires on each end. Use a crimping tool to crimp the metal connector tightly to the wires, creating a solid mass inside the connector barrel. Once both ends of the connector have been crimped to the metal connector, make sure the insulated sheath completely covers the wires. This will seal the connection and prevent contact with other surfaces and provide resistance to environmental conditions.
Depending on the application and where it is used, a butt splice connector is effective when installed correctly. Insert the wire you wish to splice to brown wire shown for example into the front slot of the connector as shown: 3. Using pliers press the metal connector onto the wires. This will cut through the insulation of both wires and make a firm electrical connection between them, all in one action: for more instruction and installation download ebook from here: Click Here!
Newer Post Older Post Home. Subscribe to: Post Comments Atom. Labels components 4 free energy 8 green 1 Hydrogen 1 installation 4 parts 2 savings 1 video 4 water car 2 water4gas
0コメント