Mrv8000c driver

Date of birth. Password Password Strength: No Password. Password confirmation. Helena St. Lucia St. Martin St. Outlying Islands U. Next Step Already Registered? I agree to inMusic's Privacy policy and Terms of Use. Back Create Account. Where to Buy. Thanks again man! Awesome, well laid-out walkthrough. One problem though I am having is, I don't have an internet connection to start on. Any suggestions there. Steps 1 - 3 are prefect. Everything seems good.

I figure it'd be fine anyways because it's just a comment. Then I added the line iface wlan0 inet dhcp on line 5 of the file. For more information, see interfaces 5 The primary network interface iface wlan0 inet dhcp And when I go to the Network Admin pannel. The wireless device is not there. The only thing is the modem device I know I don't have. I am completely lost. If anyone has any suggestions, please let me know.

Further Trouble shooting: - I tried to remove the lines other than the commented lines and only have the one pertaining to the wireless devices and it didn't work.

So, please, I'm using this for school and I'd like to have a laptop that I could use a little bit more. Well I'll be out for now. Send in posts if anyone has an idea what is going on. Peace, Newbie. The Newbie found the answer! All done through terminal. And all worked! Now I'm gonna enjoy my awesome distro of linux! Installed ndis drivers: mrv invalid driver!

I've tried the drivers that came with the card and even the downloaded one and still getting the same issue, any ideas? Hey guys. Everything installed fine. It says the driver is present and installed. It even shows up via ndisgtk. So i know its setup. I have an unsecured network, so there shouldn't be any conflicts.

Can anyone post their working configuration? This determines the proper chipset that is being used. Even the same versions sometimes have different chipsets. I looked at the ndiswrapper wiki page and yours is not listed. Based on the information you are providing, it does look like a Marvell chipset. When you did make for ndiswrapper, there were no errors and your kernel source is installed? It may be that the card is not supported.

I also noticed that a newer version is up for ndiswrapper. Perhaps try that version, if you already have not. The link is here. There are also distro specific instructions on the ndiswrapper wiki page that may help. The link to the page is here. Yes, i use the source package ndiswrapper and compile it with my kernel 2. I've tested Marvel mrvc, cb55n5x. My system is Debian Testing, all updated, wireless-tools installed. Im working with Debian since 5 years.

So, you are using the source ndiswrapper package? What distro and version is this? Windows Software ThisIsWin11 1.